Signs your main valve needs attention
- The handle will not turn, or turns without closing
- Water still trickles through when the valve is closed
- Drips or corrosion around the valve body
- An old gate valve with a round wheel handle
Replacing the main shut-off
We arrange for the Region of Peel to close the curb stop, or close it ourselves if allowed, then fit a full-bore ball valve that closes in a quarter turn. These are quick to close and rarely seize. We also check the pipe before and after the meter for corrosion.
- Arrange water shut-off at the curb.
- Remove the old valve and clean the pipe ends.
- Install a new ball valve and test.
- Hang a tag on the valve so family members spot it quickly.
Know where yours is
Typical Brampton layouts put the main by the meter on the street-side basement wall; some recent builds tuck it into a furnace room or below the staircase. Show every adult in the house where it is.
Tools, access and testing
| Tools we bring | Copper cutter, ProPress jaws, PEX crimper, moisture meter |
|---|---|
| What we open | Drywall at the leak, ceiling panels, the main valve |
| What we test | Static pressure on the line, joints under load |
Where in Brampton we do this
We take main shut-off valve replacement calls right across the city, including Fletcher's Meadow, Professor's Lake, Castlemore, Snelgrove and the streets around them.
Questions we get
How often should I test it?
Once or twice a year. Close it, check the house has no water, then reopen it fully.
